Share
Search
Tel: 888-353-0303 or 302-731-1700
Depth Filters
Pleated Filters
Membrane Filters
Specialty Filters
Filter Housings
» AFA Pleated Septa
» Dualguard I Polishing Septa
» Dualguard Pleated Septa
» Wound Precoat Septa
» TurboGuard™ Pre Filters
» TurboGuard™ Housings
» TurboGuard™ GF Series
» Thermoguard Precoat
» Nuclear Guide Rod
» Fossil Guide Rod
» AFA Tilting Guide Rod
» AFA Full Flow Guide Rod
» AFA Captive Hitch Pin
» Sealfast Adapter
» Aegis PowerGuard
» Aegis PowerGuard with Poroplate®

Have a question?


AEGIS® TurboGuard™ Pre Filters

Flow is from the inside core to the outer pleats

TurboGuard Filters are wrapped in a one-piece extruded outer cage preventing media migration during inside out flow

TurboGuard’s one-piece extruded outer cage allows for easier maintenance and removal after use

One-piece molded end caps, including molded-in bail for secure handling during installation and removal
Quad Seal gasket system to provide maximum sealing surfaces
Highest dirt holding capacity - approximately 25 lbs (11.5 Kg) before removal is required
Low pressure drop - less than 0.2 bar in service at specified flow rate

Optimized media surface area allows full use of installed media area - not blocked off by media “squeezing”


Typical Applications

» Pre-filter for protection of Deep Bed demineralizers
» Pre-filter for protection of RO membranes
» Retrofit OEM high flow large geometry filter housings



 
HTML Comment Box is loading comments...

© Graver Technologies, 2008.

Have a question?